High And Low Temperature Test Chamber Two Sides Door Open For Oil Electronic Pump

Main technical parameters ( water-cooled, temperature +25℃, no load)

-70℃ ～ +180℃(Different temperature range per customer requirements)

5.Heating up rate&Cooling down rate

from 25℃ to +150℃ whole process average≧3℃/min Load 50 kg aluminum alloy

from +25℃ to -40℃whole process average ≧2℃/min Load 50kg aluminum alloy

The temperature performance test is based on the relevant provisions of the IEC 60068 -3

standard; the sensor is placed at the unit air outlet.

Chamber structure

The test chamber adopts the overall structure, the upper part is the working chamber, the rear side is

the refrigeration unit, the lower right space (≧700mm) is vacant to install the hydraulic part device, the

right is the electric control cabinet, the control panel is located on the right front side; the width direction

opens the door , the right side is the air duct system; the air supply motor, the centrifugal fan blade, the

heater, and the evaporator.

Inner size: W 1800 × H 1200 × D 1200 mm

Outer size :W 2935 × H 2170 × D 1450 mm approx

Outer wall material: cold-rolled steel plate electrostatic double-sided spray, color ivory white;

Inner wall material: SUS304# matte stainless steel plate, thickness 1.5mm

Insulation material: rigid polyurethane foam insulation layer + glass fiber.

bottom bearing capacity: ≧150kg

The bottom of the workroom has a threaded port for mounting the work shelf